One thought on “Jensen Amp Interface

  1. 1. According to the AES48 standard, XLR Pin 1 should be first connected to the chassis ground and eventually connected at a single point to ‘0V reference’. I think that in the case of the re-amp box this clause does not apply since the main aim of the reamp box is to isolate.

    2. I am comparing the Jensen schematic and the one for the LINE2AMP RevC V3 and it seems that the two connect Pin 1 at different points. The Jensen schematic connects Pin 1 directly to the chassis at the start whilst the LINE2AMP RevC V3 seems to ground Pin 1 at the other end i.e. at the output jack. Is there a ‘preferred’ way for this?

Leave a Reply

Your email address will not be published. Required fields are marked *